Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours (And after every washing).
Grease specification: No. 2 lithium grease
The grease fitting locations and quantities are as follows:
•
Brake-shaft pivot bearings (5) as shown in
Figure 33
•
Rear-axle-pivot bushings (2) as shown in
Figure 34
•
Steering-cylinder ball joints (2) as shown in
Figure 33
g009704
1. Top fitting on kingpin
Figure
34)
•
Tie-rod ball joints (2) as shown in
•
Kingpin bushings (2) as shown in
Important: The top fitting on the kingpin should
only be lubricated annually (2 pumps).
•
Lift-arm bushings (1 per deck) as shown in
g009705
•
Lift-cylinder bushings (2 per deck) as shown in
39
Figure 35
Figure 35
Figure 35
Figure 35
Figure 36
Figure 36
g009706
g009707
Figure 36