Table of Contents
Advertisement
For ovens – converting the appliance from
natural gas to liquefied gas
If the appliance was set to natural gas at the time of
delivery (factory setting) (NG: G20, G25) and is now
being converted to liquefied gas for the first time (LPG:
G30, G31):
In order to gain access to the bypass nozzles below
1.
the burner tap, remove the control panel. You can
find additional information about this in the section
entitled "Removing the control panel" → Page 29.
Then tighten the bypass nozzle on the oven burner
2.
as far as it will go.
Then carry out the steps described in the section
3.
entitled "Installing the control panel" → Page 30.
Converting the appliance from liquid gas to
natural gas
If you convert the appliance from liquefied gas
(LPG: G30, G31) to natural gas (NG: G20, G25) or if
you already carried out this conversion and then undo
this:
Replace all of the bypass nozzles in the appliance.
1.
You can find additional information about this in the
section entitled "Removing the control panel"
→ Page 29.
Then carry out the steps in the section entitled "Re-
2.
placing the bypass nozzles" → Page 30.
Then carry out the steps described in the section
3.
entitled "Installing the control panel" → Page 30.
Removing the control panel
Remove the pan support grids or the pan support
1.
racks and the burner parts.
If burner connection screws are present on the hob,
2.
remove all of these.
Remove the two screws (T20) at the front right and
3.
left of the hob panel. Do not remove the plastic
parts that are located below these.
Note: To ensure that no scratches are formed on
4.
the matte glass plate, do not allow the underside of
the hob to come into contact with objects.
Hold the front section of the hob and tilt it upwards
at a maximum angle of 30°. Secure the hob with
the profile bar by placing it vertically on the front
burner mount.
Remove the plastic covers from the front profiles on
5.
the right and left. Ensure that the covers are not
damaged or scratched. Unscrew the screws (T20)
below these.
Installation instructions en
29
Advertisement
Table of Contents
