Install An Interface Module; Remove An Interface Module - Watchguard Firebox T80 Hardware Manual

Hide thumbs Also See for Firebox T80:

Table of Contents

01.11.22, 14:00

Install an Interface Module

To install an interface module:

1. Power oﬀ the Firebox, and disconnect the power cable.

2. Loosen the two captive screws on the expansion bay cover of the Firebox and remove the

cover.

The expansion bay contains guideposts on both sides to help you align the module.

3. Align the metal plate on the bottom of the interface module between the guideposts on both

sides.

4. Insert the interface module into the expansion bay, and push the module ﬁrmly into place.

5. Tighten the two captive screws on the interface module.

6. Reconnect the power cable to the Firebox.

7. Power on the Firebox.

When the Firebox starts, Fireware automatically detects all installed interfaces.

https://www.watchguard.com/help/docs/help-center/en-US/Content/en-US/Hardware-Guides/firebox-t80-hardware-guide.html?cshid=10002

Interface Modules are not hot-swappable. To avoid damage to the system, you

must disconnect the Firebox from the power source before you install or remove

an interface module.

Firebox T80 Hardware Guide

9/18

Table of Contents