Husqvarna 550XPG Mark II TrioBrake Operator's Manual page 24

4. Start the product and apply full throttle.
5. Release the throttle trigger and make sure that the
saw chain stops and stays stationary.
WARNING:
when the throttle trigger is in the idle
position, speak to your servicing dealer.
To do a check of the chain catcher
1. Make sure that there is no damage on the chain
catcher.
2. Make sure that the chain catcher is stable and
attached to the body of the product.
To do a check of the right hand guard
• Make sure that the right hand guard is not damaged
and that there are no defects, such as cracks.
To do a check of the vibration damping system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Product overview on page 2 for information
Refer to
about where the vibration damping system is on your
product.
To do a check of the start/stop switch
1. Start the engine.
2. Press the start/stop switch down to the STOP
position. The engine must stop.
24
If the saw chain rotates
To do a check of the muffler
WARNING:
has a defective muffler or a muffler that is in
bad condition.
WARNING:
the spark arrestor mesh on the muffler is
missing or defective.
1. Examine the muffler for damages and defects.
2. Make sure that the muffler is correctly attached to
the product.
3. If your product has a special spark arrestor mesh,
clean the spark arrestor mesh weekly.
4. Replace a damaged spark arrestor mesh.
CAUTION:
is blocked the product becomes too hot
and this causes damage to the cylinder and
piston.
Do not use a product that
Do not use a product if
If the spark arrestor mesh
544 - 009 - 07.02.2022