Husqvarna 550XPG Mark II TrioBrake Operator's Manual page 13

WARNING:
working technique can prevent kickbacks.
To start the product
To prepare to start with a cold engine
WARNING:
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
2. Pull the start/stop switch (A) out and up to set it in
choke position.
3. Press the air purge bulb (B) about 6 times or until
fuel starts to fill the bulb. It is not necessary to fill the
air purge bulb fully.
(B)
To start the product on page 13 for
4. Continue to
more instructions.
To prepare start with a warm engine
WARNING:
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
544 - 009 - 07.02.2022
Only you and the correct
The chain brake must be
(A)
The chain brake must be
2. Pull the start/stop switch (A) out and up to set it in
choke position.
3. Press the air purge bulb (B) about 6 times or until
fuel starts to fill the bulb. It is not necessary to fill the
air purge bulb fully.
4. Press down the start/stop switch (C) to set start
throttle setting.
(A)
To start the product on page 13 for
5. Continue to
more instructions.
To start the product
WARNING:
a stable position when you start the product.
WARNING:
idle speed, speak to your servicing dealer
and do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your right foot into the footgrip on the rear
handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING:
rope around your hand.
5. Pull the starter rope handle quickly and with force.
(B)
(C)
You must keep your feet in
If the saw chain rotates at
Do not twist the starter
13