Table of Contents
Advertisement
7. Configuring AudioCodes Mediant 800C SBC
3.
Configure an IP Group for the Zoom Phone Cloud system:
Parameter
Index
Name
Type
Proxy Set
IP Profile
Media Realm
SIP Group Name
SBC Alternative Routing Reason Set
Proxy Keep-Alive using IP Group settings
All other parameters can be left unchanged with their default values.
4.
Configure an IP Group for the SIP Trunk:
Parameter
Index
Name
Type
Proxy Set
IP Profile
Media Realm
SIP Group Name
All other parameters can be left unchanged with their default values.
On Hybrid SBCs (with onboard PSTN interfaces) it's recommended to leave IP Group 0
unconfigured for possible future use for PSTN Fallback.
7.12
Configuring SRTP
This section describes configuring media security.
security. The Zoom Phone System Interface needs to use SRTP only, so you need to configure the
SBC to operate in the same manner. By default, SRTP is disabled.
To configure media security:
1.
Open the Media Security page (Setup menu > Signaling & Media tab > Media folder > Media
Security).
2.
From the 'Media Security' drop-down list, select Enable to enable SRTP.
3.
Click Apply.
2
Zoom Cloud (arbitrary descriptive name)
Server
Zoom Cloud
Zoom
MR-Zoom
(According to requirement)
Alt. Route Reasons
(created in section 7.10)
Enable
3
SIPTrunk (arbitrary descriptive name)
Server
SIPTrunk
SIPTrunk
MR-SIPTrunk
(According to ITSP requirement)
This section describes how to configure media
- 38 -
Mediant 800C with ZPLS
Value
Value
Advertisement
Table of Contents
