Table of Contents
Advertisement
SCC-1 SMARTCRAFT CONNECT GATEWAY INSTALLATION MANUAL
10. Install the starboard cowl panel on the outboard. Refer to the Mercury Avator 7.5e Operation and Installation Manual
Starboard Cowl Panel Installation.
11. Install the front lower cowl panel on the outboard. Refer to the Mercury Avator 7.5e Operation and Installation Manual
Front Lower Cowl Panel Installation.
12. Install the front upper cowl panel on the outboard. Refer to the Mercury Avator 7.5e Operation and Installation Manual
Front Upper Cowl Panel Installation.
13. Install the battery in the outboard. Refer to the Mercury Avator 7.5e Operation and Installation Manual Battery
Installation.
Module Configuration
IMPORTANT: For configuration of the SmartCraft CONNECT module, a mobile device and a Wi‑Fi connection with access to
the internet is required.
IMPORTANT: If using a SIMRAD® with NSX™ software, Garmin®, or a Raymarine® display, visit their websites to make
sure the display is running the latest software available.
Consumer Configuration Process
NOTE: Wireless‑only SmartCraft CONNECT module versions only need to complete the firmware update, and do not need to
go through the configuration steps. See Mercury Dealer or OEM Configuration Process: Step 12 .
1.
Download the SmartCraft Manager app from the iOS App Store or Google Play Store.
2.
After the app has been downloaded to the device, open the app to begin the configuration process.
3.
Allow for Bluetooth® connectivity to use the configuration app.
Page 6 / 23
© 2023 Mercury Marine
73578
75307
90-8M0219240 eng MAY 2023
Advertisement
Table of Contents
