Advertisement
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1
Removing an Existing Rollover
Protection System (ROPS)
No Parts Required
Procedure
This procedure is only needed if there is an existing ROPS
system that needs to be replaced.
1. Make sure all moving parts have stopped, parking brake
is engaged, and the key has been removed.
2. Disconnect the negative battery cable.
3. Remove the bolts, nuts, washers and spacers attaching
the ROPS to the frame. Note the position and
orientation of the curved washers used with the bolts.
Also note the position and orientation of the flat
spacers between the ROPS legs and frame bracket.
4. Remove the ROPS from the mower. Carefully pull the
fuel vent assembly from the right ROPS leg and note
the orientation.
Description
No parts required
Upper tube
Right ROPS leg
Left ROPS leg
Carriage bolt (1/2 x 3-1/2 inch)
Bolt (1/2 x 4 inch)
Round spacer
Spacer
Locknut (1/2 inch)
Bolt (1/4 x 5/8 inch)
R-clamp
Manual tube
Qty.
Remove an existing Rollover Protection
–
System (ROPS).
1
1
1
2
4
Install the Rollover Protection System
2
(ROPS).
2
6
2
2
1
2
Installing the Rollover
Protection System (ROPS)
Parts needed for this procedure:
1
Upper tube
1
Right ROPS leg
1
Left ROPS leg
2
Carriage bolt (1/2 x 3-1/2 inch)
4
Bolt (1/2 x 4 inch)
2
Round spacer
2
Spacer
6
Locknut (1/2 inch)
2
Bolt (1/4 x 5/8 inch)
2
R-clamp
1
Manual tube
Procedure
If needed, remove the plastic ties holding the fuel vent
assembly to the engine for shipping.
2
Use
Advertisement
