Figure 4
1. Carriage bolt (1/2 x 3-1/2
inch)
2. Upper tube
3. Flange nut (1/2 inch)
4. Round spacer
5. Bolt (1/2 x 4 inch)
4. Tighten the two hinge bolts and then the four mounting
bolts. Torque the mounting bolts to 75 ft-lb (102 N-m).
Note: Not every machine comes with a manual tube.
If your machine does come with a manual tube then
proceed to step 5.
5. Install the manual tube to the left ROPS leg with 2
bolts (1/4 x 5/8 inch) and 2 R-clamps (Figure 5).
6. Curved washer
7. Flange nut
8. Spacer
9. Left ROPS leg
10. Right ROPS leg
g0181 11
Use for kits with manual tubes only.
1. Manual tube
2. Bolt (1/4 x 5/8 inch)
6. Reconnect the negative battery cable.
4
Figure 5
3. R-clamp