Advertisement
WARNING
Ensure the fuel vent hoses are connected or fuel
may leak and violate emissions regulations.
• Do Not operate the unit unless the fuel vent
assembly is installed.
• Do Not weld, drill or modify roll bar in any way.
1. Slide the fuel vent assembly into the new Right hand
ROPS leg so that the holes align with the mounting
holes in the leg (Figure 2).
1. Right leg
2. Loosely install the ROPS legs onto the machine with 4
bolts (1/2 x 4 inch), 4 curved washers, 2 spacers and 4
flange nuts (1/2 inch). Ensure the spacer is oriented as
shown in Figure 3.
Figure 2
2. Fuel vent assembly
(ensure it is oriented
correctly with the mounting
holes in the right leg)
1. Flange nut (1/2 inch)
2. Spacer
3. Curved washer
3. Place the round spacers in the ROPS legs and assemble
the upper tube to the lower legs with 2 carriage bolts
(1/2 x 3-1/2 inch) and 2 flange nuts (1/2 inch) as
shown in Figure 4.
3
Figure 3
4. Bolt (1/2 x 4 inch)
5. Fuel vent hoses
6. Right ROPS leg
Advertisement
