Rcd (Residual Current Device); Exploitation - Philips AWH1626/51 User Manual

RCD (residual current device)

• Prevention of electrical leakage
• Follow the installation instructions when
connecting the water heater
• Connect the power plug to the mains, press
the button on the front side of the RCD (3),
the indicator light will light up
• To test the RCD, press the TEST button (2)
The Power indicator (1) will be off.
• To restart the RCD, press button (3)
2
1
3
fig
5
12

Exploitation

Turning on the water heater
1 Open one of the hot water outlet valves,
then open the cold water supply valve The
electric water heater will begin to fill with
water. When water flows freely from the
hot water tap, this means that the water
heater is completely filled with water and
the hot water outlet tap can be closed
2 Insert the electrical plug into the socket
Attention!
During normal operation, the cold water
supply tap must be set to the «open»
position
1
2
3
5
4
fig
6
1 Temperature regulator
2 Power indicator
3 Heating indicator
4 LED display
5 Electronic anode indicator
Setting the water heating temperature
1 The temperature of the water in the water
heater can be set between +30 and +75 °C
2 Press the temperature regulator [1] and
hold down for 3 seconds to turn on the
water heater
3 Then turning the thermostat knob clock-
wise increases the water heating temper-
ature Counterclockwise, you measure the
heating temperature
4 The water heater automatically maintains
the water temperature When the temper-
ature of the water inside the water heater
reaches the temperature set by the user,
the heating is automatically turned off,
while the "Heating" indicator on the con-
trol panel goes out When the temperature
of the water inside the water heater drops
to a certain level, the heating automatically
turns on, while the "Heating" indicator on
the control panel lights up
Indicators:
«Power» [2] – the indicator lights up when the
device is connected to the mains
«Heating» [3] — the indicator lights up when
the process of heating water in the tank is in
progress
Attention!
During heating, water may start to drip
from the opening of the safety valve Water
leakage cannot be avoided and must not be
prevented, since blocking the valve can lead
to rupture of the internal tank (in the event
of an equipment failure)
Shutdown
To turn off the water heater, press the tem-
perature control knob [1] and hold down for
3 seconds The water heater will stop working
It is recommended to always disconnect the
water heater from the electrical mains if you
do not plan to use the appliance for some time
13