Installation - Philips AWH1626/51 User Manual

Installation

1 The water heater should be installed on
a solid wall The wall on which the elec-
tric water heater is to be installed must
be capable of supporting at least twice
the weight of the water heater when ful-
ly filled with water, and the wall must be
free of cracks and other damage Other-
wise, it is necessary to take measures to
strengthen the fastening or install the
water heater on a special support
2 If the bathroom is too small, the water
heater can be installed in another place,
closed from direct sunlight and inaccessi-
ble to moisture However, to reduce heat
losses in the pipelines, the installation site
of the water heater should be as close as
possible to the point of use of hot water
1
2
9
3
* 6
4
*
7
5
*
fig 3
* Not included in the scope of delivery
8
Water heater installation methods
The installation method of the water
heater for one consumption point is shown
in fig. 3.
Attention!
The water heater must be installed on a
vertical wall in a strictly vertical position
Installing the device in any other position
or skew relative to the vertical will inevita-
bly lead to the failure of the water heater,
creating an emergency and is considered by
the manufacturer as a non-warranty case.
1 Power cord with plug and RCD
2 Hot water outlet
3 Hot water flow control tap
4 Faucet *
5 Shower head
*
6 Cold water inlet tap
*
7 Drain tube
8 Combined safety valve
9 Cold water inlet
10 Dielectric coupling Static CARE
10
8
The installation method of the water heater for several consumption points is shown in
fig. 4.
*
1 Power cord with plug and RCD
2 Mounted water heater
3 Combined safety valve
4 Cold water inlet tap*
5 Faucet*
6 Shower head*
7 Water main shut-off valve*
* Not included in the scope of delivery
1
14 12
13
11
3
8
4
5
10
fig 4
8 Drain tube
9 Water supply
10 Bath*
11 Tee*
12 Inlet pipe
13 Outlet pipe
14 Dielectric coupling Static CARE
2
6
Cold water
7 9
9