Huawei OptiXstar EN8245X6s-8N Quick Start Manual page 7

Huawei OptiXstar EN8245X6s-8N
Quick Start for QR code
No.
1
2
3
4
5
6
7
8
9
Issue 02 (2022-12-14)
Item
Reset
TEL1-TEL2
LAN1-LAN3/2.5G LAN
USB
On/Off
Power
Optical port
WPS
WLAN
Copyright © Huawei Technologies Co., Ltd.
Description
Press the button for a short time to reset
the device, or press the button for a long
time (longer than 10s) to restore the
device to the default settings and reset the
device.
NOTE
Reset Huawei ONTs with caution. Otherwise,
the ONTs may fail to access the Internet. If an
ONT cannot access the Internet after a reset,
contact your Internet service provider.
Connects to the ports on a telephone or
fax machine.
Connects to PCs or IP set-top boxes (STBs).
Connects to USB storage devices.
Powers the ONT on or off.
Connects to a power adapter.
The optical port is equipped with a rubber
plug and connected to a fiber for upstream
transmission.
The type of the optical connector
connected to the optical port can be SC/
APC.
NOTE
Before the optical fiber is connected to the
optical port on the ONT, remove the fiber port
cover on the ONT in the arrow direction, lead
the fiber out of the ONT through the hole on
the fiber port cover, and then install the fiber
port cover to the ONT.
When the WLAN is on, press the WPS
button (> 3s) and release the button to
start Wi-Fi protected setup (WPS)
negotiation.
Used to enable or disable the WLAN
function.
● When the WLAN is off, press the WLAN
button (> 3s) and release the button to
open the WLAN.
● When the WLAN is on, press the WLAN
button (> 3s) and release the button to
close the WLAN.
2 Connecting Cables
4