Honda FSH125 2020 Manual page 118

20201020145810_32K1NB000_eng_BOOK Page 118 Tuesday, October 20 2020 15:02:25 JST
ID number input success
After the last ID number is inputted, through,
the ignition switch ring and Honda SMART
Key Indicator will flash every 2 seconds until
the EM mode coupler is removed.
Be sure to remove the EM mode coupler and
return the blue dummy coupler. The ignition
switch is then unlocked. Reinstall the parts in
reverse order of removal and turn the ignition
switch to the (On) position within 6 minutes. You
can start the engine.
To lock the ignition switch, turn the ignition switch
to the SEAT, (Off), or
press and hold the ignition switch for 2 seconds.
The ignition switch also locks automatically when
the ignition switch has been in the SEAT,
or (Lock) position for about 6 minutes after the
ID number is successfully inputted.
When the ignition switch is locked, the ignition
switch ring goes off.
To unlock the ignition switch again, repeat the
procedure for unlocking the ignition switch.
ID number input failure
After the last ID number is inputted, the
ignition switch ring and Honda SMART Key
Indicator will flash every second until the EM
mode coupler is removed, and the ignition
switch cannot be unlocked.
Pull out the EM mode coupler and reconnect
it to the EM mode connector. Follow the
procedure again.
ID number input cancel
Pull out the EM mode coupler from the EM
mode connector.
(Lock) position, and
Also, if you make a mistake while inputting the
ID number, remove the EM mode coupler from
the EM mode connector, connect it to the EM
mode connector again, and then re-input the
(Off),
ID number from the beginning.
Unlock the Ignition Switch in an Emergency
P. 114
2
Store the removed EM mode coupler in
●
the tool kit at all times.
115