RCF SUB 8005-AS Owner's Manual page 7

1
2
1 MAIN SIGNAL XLR INPUT (BAL/UNBAL). The system accept female XLR input connectors
and line-level signals from a mixing console or other signal source.
2 SIGNAL LINK XLR OUTPUT. The output XLR male connector provides a loop trough for
speakers daisy chaining.
3 XOVER SIGNAL OUTPUT. The output XLR male connector provides a crossover high passed
signal (24 dB/octave) for satellites speakers.
INPUT SENSITIVITY. Controls the overall signal level at the input to the power amplifier. The
4
control ranges from + ∞ dBu (maximum attenuation) to the –2 dBu – MAX sensitivity (maxi-
mum input gain). The centre detent is +4 dBu (nominal level required to drive the amplifier at
maximum power).
5 DEEP - PUNCH. This switch provides a DEEP equalisation (flat response down to 30 Hz) or
a PUNCH equalisation with a boosted equalisation at 70 Hz.
6 XOVER 90/120 HZ. Provides 24 dB/octave low-pass filtering at 90 Hz if released, at 120
Hz if pressed. The same crossover frequency in high-pass is available from XOVER OUTPUT XLR.
TIME DELAY ENCODER. This encoder provides a time delay setting expressed in meters.
7
4
5
6
11
12
3 7
REAR
PANEL
10
9
13
8
14
SUB 8006-AS
SUB 8004-AS
SUB 8005-AS
7