Mul-t-lock HaspLock Diamond Installation And Service Instructions page 2

1
Installation with screws
Mark position of fixing screws (Fig 1).
Drill holes for M8 screws.
Allow a gap of 2 mm between lock parts.
Screws position can be slightly adjusted according to
installation
.
Fig 1
HaspLock DIAMOND position
for double swing door or
Door edge
sliding door (Fig 2).
Fig 2
5
Welding adaptor kit - P/N 28500291
The kit includes:
• 2 Metal welding adaptors
• 4 nuts M8 DIN 934 or DIN 439
• 4 socket head screws M8X16
Assemble the welding adaptors to the HaspLock Diamond using 4 nuts
and screws.
Welding adaptor
Nut
Screw
2
Place the HaspLock DIAMOND on the door. Slightly
fasten M8 fixing screws with screw nuts (Fig 3).
Note: Check that the door can be opened and closed
properly before complete tightening of the screws.
Nuts
Door
Door
frame
Fig 3.
A B
When using side screws, drill through holes in the frame,
mount the screws and secure with nuts (Fig 4).
Nuts
Door
Door
frame
Wall
Fig 4.
A B
Note: Rivet or weld the nuts in order to protect from
unauthorized disassembling.
6
Follow welding process described in para. 3-4.
Use steel electrodes to weld the metal welding
adaptors.
3
Installation by welding
Warning:
To avoid any damage to the cylinder and mechanism
remove them from HaspLock DIAMOND housing prior
to the welding process.
See cylinder removal process on para. 6-8.
Clean surface to be welded from paint/dirt/grease etc.
Insert the supplied spacer between the two parts (Fig 5).
Hold the two parts and Insert the locking bolt to ensure
proper alignment of the parts. Take the bolt out.
Fig 5.
Spacer
Bolt
Nuts
7
General view
1
2
4 8
9
11
7 3
6
5
No. Description
1 Body 1 for HaspLock DIAMOND
2 Latch for HaspLock DIAMOND
3 Bolt for HaspLock DIAMOND
4 Activator
5 Cylinder holder
6 Shutter
7 Spring for slider
8 Spring for latch
9 Pin
10 Counter body
11 Cylinder
4
Use special steel/stainless steel electrodes to weld the
HaspLock DIAMOND temporarily in few welding points.
Remove the spacer. Check a free movement of the bolt
inside the two parts. Check for proper operation of the
door. Complete welding areas.
Seal cylinder and bolt openings and paint over the
welded parts with appropriate rust-resistant paint.
Note: when completing assemble the cylinder and
mechanism. See service chapter on Para. 11-14. Check
for proper operation of the lock and the door.
See two options: left swing door (Fig 6) and right swing
door (Fig 7).
Door edge
Fixed part
Welding
areas
Door frame Door
Fig 6.
8
HaspLock DIAMOND service
Unlock padlock with operating key.
Pull the bolt (Fig 8) until holes in the bolt and lock
body are parallel (Fig 8a). Use a small tool to press
the pins (9) and remove the bolt by pulling it out
carefully.
10
Fig 8
P/N
28500261
28500266
28500262
28500263
28500146
28500144
28200150
28500207
28500267
28500264 Fig 8a
-
Door edge
Fixed part
Door Door frame
Fig 7.
9