XP Metal Detectors DEUS II WS6 MASTER Quick Start Manual

V1.0 of the

Tones - Threshold and tones settings

Press
1
TONE
T.BREAK
Press
100
Customize the sound partitioning of the discrimination range. A volume level (0 to 10) and
a sound frequency (comparatively low- or high-pitched) is assigned to each part of the
Hz
discrimination range. Press
VOLUME (VOL) and set them using + and - .
Volume of the low-pitched tone (tone 1) is the same as the Iron Volume.

Full tones

TONES
With Full Tones, the ground area is audible from -6.4. The discrimination setting acts as
a "tone break," and the Iron Volume setting adjusts the volume of ground and ferrous
FULL
below the discrimination level.
TONES
Full tones - Threshold and volume settings
From Full Tones, press
T.BREAK VOL
Customize the sound partitioning of the discrimination range for Full Tones and Adjust
35
volume levels of each tone independently.
Press
using + and - .

Offset Full tones

the OFFSET FT feature allows the user to shift the "Full Tone" audio frequencies of tar-
OFFSET FT
gets with a signature just above the Discrimination threshold, in order to better differen-
5
tiate them audibly from iron.
0 = no offset
40 = all targets above discrimination will sound with the same high tone.

Multi-Notch

Select
NOTCH 2
This advanced notch function enables you to widen the rejection window in the event
28-46
that the undesirable target(s) have a fluctuate conductivity. Select Tone break 1 or 2 with
(3 sec). Adjust the values
If several targets with different conductivity levels are a problem, you can activate two
other notches: N2 and N3. Use

Threshold

(Only with Pitch mode ON)
THRESHOLD
The tone of the Threshold (and the deepest / smallest targets) can be modified from 150
2
to 603 Hz. Press
WS6 MASTER
introduces some new features/modifications described below :
> > (3 sec). Choose
DISCRI
(3 sec) to access the
to choose the TONE BREAK (T. BREAK) or the VOLUME (VOL) and set them
(Only with Full Tones mode ON)
5 = (default value) creates a little offset
NOTCH 1 inside MENU
(3sec) and adjust it with
2 Tones - 3 Tones - 4 Tones - 5 Tones.
MULTI TONES screen.
to choose the Tone, the TONE BREAK (T. BREAK) or the
(3sec).
> DISCRI and press
and .
to select N2 or N3 and adjust as for N1.
(3 sec).
and
.
V1.0
1