Adjustments - Carrier PG96MSA Installation, Start-Up, Operating And Service And Maintenance Instructions

PG96MSA: Installation, Start-up, Operating and Service and Maintenance Instructions
Prime Condensate Trap with Water
WARNING
!
CARBON MONOXIDE POISONING HAZARD
Failure to follow these warnings could result in personal injury or
death.
Failure to use a properly configured trap or NOT water-priming trap
before operating furnace may allow positive pressure vent gases to
enter the structure through drain tube. Vent gases contain carbon
monoxide which is tasteless and odorless.
CAUTION
!
UNIT OPERATION HAZARD
Failure to follow this caution may result in intermittent unit operation
or performance satisfaction.
Condensate trap must be PRIMED or proper draining may not occur.
The condensate trap has two internal chambers which can ONLY be
primed by pouring water into the inducer drain side of condensate trap.
1. Remove upper and middle collector box drain plugs opposite of the
condensate trap. See Fig. 61.
2. Connect field-supplied 5/8-in. (16 mm) ID tube with attached
funnel to upper collector box drain connection.
3. Pour one quart (liter) of water into funnel/tube. Water should run
through collector box, overfill condensate trap, and flow into open
field drain.
4. Remove funnel; replace collector box drain plug.
5. Connect field-supplied 5/8-in. (16 mm) ID tube to middle collector
box drain port.
6. Pour one quart (liter) of water into funnel/tube. Water should run
through collector box, overfill condensate trap, and flow into open
field drain.
7. Remove funnel and tube from collector box and replace collector
box drain plug.
Fig. 61 – Priming Condensate Trap
Purge Gas Lines
If not previously done, purge the lines after all connections have been
made and check for leaks.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
FIRE OR EXPLOSION HAZARD
Failure to follow this warning could result in personal injury, death,
and/or property damage.
Never purge a gas line into a combustion chamber. Never test for gas
leaks with an open flame. Use a commercially available soap solution
made specifically for the detection of leaks to check all connections. A
fire or explosion may result causing property damage, personal injury
or loss of life.

ADJUSTMENTS

FIRE HAZARD
Failure to follow this warning could result in personal injury, death
and/or property damage.
DO NOT bottom out gas valve regulator adjusting screw. This can
result in unregulated manifold pressure and result in excess overfire and
heat exchanger failures.
FURNACE DAMAGE HAZARD
Failure to follow this caution may result in reduced furnace life.
The 26,000 BTUh model has a lower nominal manifold pressure than
other models. Do not adjust the natural gas manifold pressure above
1.8-in. w.c.
The 26,000 BTUh model can be identified by the green label affixed to
the solenoid of the gas valve.
Refer to the Adjustment section for setting the manifold pressure.
USE Table 26 WHEN ADJUSTING 26,000 BTUh MODEL
MANIFOLD PRESSURE.
FURNACE DAMAGE HAZARD
Failure to follow this caution may result in reduced furnace life.
DO NOT redrill orifices. Improper drilling (burrs, out-of-round holes,
etc.) can cause excessive burner noise and misdirection of burner
flames. This can result in flame impingement of heat exchangers,
causing failures. See
A11392
56
WARNING
!
WARNING
!
CAUTION
!
CAUTION
!
Fig. 62.
BURNER
ORIFICE
A93059
Fig. 62 – Orifice Hole
A93059