Cleaning And Maintenance - homelabs HME030438N User Manual

Cleaning and Maintenance

CLEANING
Clean the fridge interior to avoid odors. Exterior cleaning can improve energy efficiency. Follow the cleaning
procedure below:
1. Unplug the fridge.
2. Wipe the door seal with warm water using a damp cloth or sponge.
3. Remove the tempered glass shelves. Wash them with mild soap and warm water. Dry them or allow
them to air dry completely.
4. Use mild soap and warm water to clean the exterior and interior of the fridge.
5. Reconnect the fridge when the fridge is clean and dry.
6. Allow the fridge to run for 2 to 3 hours before adding any fresh or frozen foods.
7. In the summer or during hot weather, allow the fridge to run for at least 4 hours in advance before
adding any food.
NOTE:
• Unplug from the socket before cleaning or defrosting.
• Do not use hard brushes, wire brushes, abrasives, organic solvents, boiling water, acid, or alkaline
items for cleaning or defrosting as this may damage the surface and interior of the unit.
• For areas that are difficult to clean in the fridge (such as narrow sections, gaps or corners),
wipe with a soft rag or soft brush. If necessary, use some auxiliary tools to clean these areas,
making sure that no contaminants or bacteria accumulate.
• Do not rinse directly with water or other liquids during cleaning to avoid short circuits or affect
electrical insulation after immersion.
NOTE: Do not immerse refrigerator.
DEFROSTING
1. Unplug the fridge.
2. Remove the food from the fridge and place it properly to prevent food from melting or spoiling.
3. Clear the chamber with a soft cloth. Prepare the water container for defrosting. Pay attention when
cleaning the water drip tray near the compartment. Avoid overflow to the ground.
4. You can defrost naturally at room temperature, or use a plastic or wooden ice shovel to carefully
eliminate the frost.
5. You can also use the appropriate amount of hot water to speed up the defrosting. Use a dry towel to
absorb the water after defrosting.
6. After defrosting, store the foods back in the freezer compartment.
7. Power on the fridge.
8. Allow the fridge to run for 2 to 3 hours before adding any fresh or frozen foods.
9. In the summer or during hot weather, allow the fridge to run for at least 4 hours in advance before
adding any food.
STORAGE REQUIREMENTS
If the unit will remain unused for an extended period, unplug and defrost freezer. Wash interior and
completely dry the appliance. Store the refrigerator upright in a dry, well-ventilated location.
13