Toshiba MV-SAM20T Instruction Manual page 223

OPERATION
toshiba_b0_
toshiba_b0_
14. Turn to WLAN setting page and
connect to
toshiba_b0_xxxx
Using 12345678 as pass-code.
When an error message "N " appears on the display, please check the following table.
Error
N0 The module cannot be found.
The connection to the router failed and the router signal was poor.
N1
Router Wi-Fi could not be found.
N2
The connection to the router failed. The Wi-Fi password is incorrect.
N3
Connection to router failed, good signal and no password error reported.
N4
Connection to router successfully but the server could not be
N5
connected overtime. (including domain name resolution error)
15. Go back to
*
Possible Cause
EN-34
INSTRUCTION FOR USE
Wait until " " sign is
normally on display.
If the connection fails, the error
code "N0~N5" is displayed for
3 seconds. Other errors show
"FFFF" for 30 seconds. Please
try the link again.
.