Mount Hitch To Tow Vehicle; Connecting Power Wire To Vehicle Battery; Aerator To Hitch; Battery Harness To Switch - Jrco 753 Operator's Manual

NOTE: Park mower/UTV close to clevis area.

2.14 Mount Hitch to Tow Vehicle

1. Position hitch so clevis pin slots are approximately
11 ½" from ground and slots are vertical.
2. Drill holes in hitch and attach hitch to vehicle
framework or drawbar using 5/16" bolts.
1. Connect supplied battery wire directly to battery

2.15 Connecting Power Wire to Vehicle Battery

terminals. Route battery cable, back to hitch, along
vehicle frame. Safely away from pinch points and
rotating parts, and secure with cable ties.
1. Align the tow tongues with the slots in the hitch.

2.16 Aerator to Hitch

Choose the slots that will keep the aerator level.
Attach with clevis pins and safety clips.
Plug the battery harness and power wire into the switch

2.17 Battery Harness to Switch

harness. Route the switch harness up to the vehicle
operator.
Secure with cable ties and hook and loop ties.
20195 South Diamond Lake Road, STE 100
Rogers, MN 55374
800.966.8442
MODEL 753 Operator's Manual
Figure 1-7
Figure 1-9
13