Table of Contents
Advertisement
Installation
5.6 Fitting an extender
Fitting and removing an extender
Fitting an extender
To fit an extender, follow the steps below:
1. Remove the cover of the expansion interface on the basic device.
2. Fit the two devices together so that the two centering pins are accommodated by the
opposing openings
3. Press the devices together until they are flush.
The centering pins click audibly into place. The locking device is automatically pressed up
briefly as this happens.
Removing an extender
To remove an extender, follow the steps below:
1. Release the locking device using a screwdriver
The two devices are separated from each other.
2. Pull the two devices apart in a straight line
of the openings.
50
①
.
②
①
.
until the two centering pins are completely out
Operating Instructions, 03/2021, C79000-G8976-C306-10
SCALANCE XM-400
Advertisement
Table of Contents
