Table of Contents
Advertisement
How to remove the belt (TAPE 2) (See Fig. 13-1)
1. Remove the main belt (D1) x 1 pc., from the motor side.
2. Remove the FF/REW belt (D2) x 1 pc.
How to remove the belt (TAPE 1) (See Fig. 13-1)
1. Remove the main belt (E1) x 1 pc., from the motor side.
2. Remove the FF/REW belt (E2) x 1 pc.
How to remove the motor (See Fig. 13-2)
1. Remove the screws (F1) x 2 pcs., to remove the motor.
FF/REW
TAPE 2
Belt
(D2)x1
(D1)x1
Figure 13-1
CD MECHANISM SECTION
Perform steps 1, 2, 3, 13 and 16 of the disassembly method
to remove the CD mechanism.
How to remove the loading motor
(See Fig. 13-3)
1. Bend the hooks (A1) x 5 pcs., to remove the loading motor.
2. Remove the drive belt (A2) x1.
How to remove the pickup (See Fig. 13-4)
1. Remove the stop washer (B1) x 1 pc., to remove the gear
(B2).
2. Remove the screws (B3) x 2 pcs., to remove the shaft (B4).
3. Remove the pickup.
Note
After removing the connector for the optical pickup from the
connector, wrap the conductive aluminium foil around the
front end of connector to protect the optical pickup from
electrostatic damage.
Motor
Motor
TAPE 2
Main Belt
(D1)x1
TAPE 1
FF/REW
Belt
(E2)x1
(E1)x1
TAPE 1
Main Belt
(E1)x1
(F1) x2
Ø2.6x5mm
Slide Chassis
(B3) x2
ø2.6 x6mm
Shaft
(B4) x1
– 13 –
CD-K7000V,CP-C7000
Figure 13-2
Loading Motor
(A1)x3
(A1)x2
Pulley
Figure 13-3
Stop Washer
(B1) x1
CD Mechanism
Gear
(B2) x1
Figure 13-4
Motor
Motor
Drive Belt
(A2) x1
Pickup
Advertisement
Table of Contents
