Page 1
P H O N O S TA G E USER GUIDE: R-180 / R-280 / R-580...
Page 2
THE EQUIPMENT SHOULD BE SERVICED BY QUALIFIED SERVICE PERSONNEL 1. Read these instructions. 10. Only place apparatus horizontally and on – Take care that objects do not WARNING a suitable table or rack. fall and liquids are not spilled into the 2.
Page 3
BUTTONS ON THE FRONT OF THE PHONO STAGE CONNECTORS ON THE BACK OF THE PHONO STAGE ON / OFF ON / OFF LEFT RIGHT RIAA R·180 - MADE IN DENMARK LEFT RIGHT RIAA R·180 - MADE IN DENMARK PHONO PHONO RS-232 TRIGGER THROUGH...
FRONT PANEL FUNCTIONS If you are using an Apple remote, you can pair the DISPLAY phono stage with one specific remote. In order to pair During normal operation the display shows the source your remote control with the phono stage, press and (Phono).
50 Ohm to 10 kOhm. Please see “MENU cables with an IEC 60320-C13 female connector. FUNCTIONS” on page 7 for guidance. To ensure the best performance, please consult your Aavik Acoustics dealer for a suitable mains cable. LEFT RIGHT RIAA R·180...
APPLE REMOTE A A A A A A A VOLUME UP, Used for changing menu settings. VOLUME DOWN, Used for changing menu settings. INPUT +, Used for changing menu settings. INPUT -, Used for changing menu settings. STANDBY, Press this button to place the phono stage in standby mode, or to switch the phono stage on from standby mode.
MENU FUNCTIONS Using the front panel or remote control, you can change many settings of the phono stage. Using the remote, you press the “Menu” button to enter or exit the menu. Using the front panel, you press and hold the navigation button for 3 seconds.