AAVIK M-300 MONO User Manual

Advertisement

M-300 Mono power amplifier
User's guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the M-300 MONO and is the answer not in the manual?

Questions and answers

Summary of Contents for AAVIK M-300 MONO

  • Page 1 M-300 Mono power amplifier User’s guide...
  • Page 2 M-300 Mono power amplifier User’s guide Specifications: Contents: SPECIFICATIONS Page 2 Power output: 8Ω: 290W, 0.01% THD 4Ω: 580W, 0.01% THD SAFETY INSTRUCTIONS Page 3 FRONT PANEL FUNCTIONS Page 4 Input impedance: 11kΩ (XLR), 12kΩ (RCA) REAR PANEL FUNCTIONS Page 6...
  • Page 3 Safety instructions The amplifier should be serviced by qualified service personnel 1. Read these instructions. The amplifier should be serviced by qualified service personnel when: 2. Keep these instructions. A. the power-supply cord or the plug has been damaged, or B.
  • Page 4 M-300 Mono power amplifier User’s guide Front panel STANDBY/POWER INDICATORS When the amplifier is in standby mode, the only light showing on the amplifier will be a dim LED light above the rocker button. With the amp on, the brightness of the LED increases, and the right and left sides of the display window will be diffusely lit.
  • Page 5 Front panel functions The DC indicators may switch on during power up, and then switch off again after a couple of seconds. This is just the DC levels of the preamplifier or power amplifier that take a bit of time to stabilise. This causes no problems, and is not an error.
  • Page 6 4mm banana plugs. To ensure the best performance, please consult your Aavik Acoustics dealer The positive speaker terminal is white, and the negative is black. for a suitable mains cable.
  • Page 7 Personal notes: Page 7...
  • Page 8 www.aavik-acoustics.com...

Table of Contents