Robo-Tek Robo-Plus V2 User Manual
Please read this manual carefully before using the Pool Cleaner
1. Safety Warnings
•
Before performing maintenance or service on the Pool Cleaner please ensure the power is disconnected to
avoid personal injury or property loss.
•
The Pool Cleaner is designed for use in swimming pools only. Any other use is prohibited, and no warranty
will be provided.
•
Do not swim in the pool whilst the Pool Cleaner is in use in order to avoid personal injury.
•
Do not allow the Control Box to come in contact with water and it is recommended to be stored in a dry and
shaded area, out of the weather.
•
Do not cover the Control Box whilst Pool Cleaner is in use, to avoid overheating.
•
When in use, the Control Box and Caddy Cart must remain 3 meters away from the edge of the pool.
•
Do not use the Pool Cleaner if there is a chance of thunderstorm to avoid personal injury.
•
Ensure the Pool Cleaner is fully submerged before turning the Control Box on. If the robot is not fully
submerged, the control box will flash a green light (out of water error code) and the robot will need to be
restarted.
•
After use, make sure the Control Box is disconnected from the pool cleaner, manually rewind the lead and
place on the caddy, then store robot on the caddy in a safe, dry and well-ventilated area.
•
If the Pool Cleaner stops working, please refer to the" Troubleshooting section" of this manual. If you
cannot find the root cause, please contact your local distributor.
•
Do not lift the Pool Cleaner using the floating cable, as no warranty will be provided for cable misuse. Only
lift the Pool Cleaner out of the water by using the Pool Cleaner handle. You can use the floating cable to pull
the robot closer to the side of the pool but, do not lift the robot by the cable out of the water.
•
Alternatively, you can drive the robot up the wall backwards (with the handle facing up towards you) grab,
the handle as it surfaces, assist the robot over the top of the pool edge, then turn the robot off using the
remote control.
•
Remove the robot from the pool after use.
•
Avoid direct sunlight when not in use.
•
Do not use the Pool Cleaner more than 4hrs at a time.
•
The optimum working temperature for the Pool Cleaner is between 10℃ and 35℃,
•
Ensure the electrical outlet is protected by a ground fault interrupter (GFI) or an
•
earth leakage interrupter (ELI).
•
If the supply cord is damaged, contact your local distributor for guidance.
•
Children should be supervised to ensure that they do not play with the appliance.
•
This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge, if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
•
Cleaning and user maintenance shall not be made by children without supervision.
Jan 2023
-