ROBO-TEK Robo-Plus V2 User Manual

Robo-Plus V2
User Manual and Safety Warnings
Please read this manual carefully before using the Pool Cleaner.
Before performing maintenance or service on the Pool Cleaner please ensure the power is
disconnected to avoid personal injury or property loss.
The Pool Cleaner is designed for use in swimming pools only. Any other use is prohibited and no
warranty will be provided.
Do not swim in the pool whilst the Pool Cleaner is in use in order to avoid personal injury.
Do not allow the Control Box to come in contact with water and it is recommended to be placed in
a dry and shaded area.
Do not cover the Control Box whilst Pool Cleaner is in use, to avoid overheating.
When in use, the Control Box and Caddy Cart must remain 3 meters away from the edge of the pool.
Do not use the Pool Cleaner if there is a chance of thunder storm to avoid personal injury.
Ensure the Pool Cleaner is fully submerged before turning the Control Box on.
After use, make sure the Control Box is disconnected from the pool cleaner and store everything
in a safe, dry and well-ventilated area.
If the Pool Cleaner stops working, please refer to the"Troubleshooting"section of this manual.
If you cannot find the root cause, please contact your local distributor.
The optimum working temperature for the Pool Cleaner is between 10℃ and 35℃，
Avoid direct sunlight when not in use.
Remove the robot from the pool after use
The Pool Cleaner is suitable for the swimming pools no deeper than 3 meters.
Lift the Pool Cleaner out of the water by using the Pool Cleaner handle.
Do not lift the Pool Cleaner using the floating cable, as no warranty will be provided for cable misuse.
Do not use the Pool Cleaner more than 4hrs at a time (limit of 8Hrs applies for
commercial pool cleaners.).
Ensure the electrical outlet is protected by a ground fault interrupter (GFI) or an
earth leakage interrupter (ELI).
If the supply cord is damaged, order a replacement cable from the local distributor.