Advertisement
4.3
Attach the leg frames to the support frame using two M14 x 25mm
bolts with washers and nuts for each leg (see Fig.3) To help with
the alignment of the holes tighten the outside bolts first then insert
the end bolts and leave them finger tight.
4.4
Lay the leg tie-bar centrally from one leg crosspiece to the other
and align the holes. Insert a bolt at each end and fix with a washer and nut
as shown in Fig.4.
4.5
Attach the two leg braces between the legs and the main support
frame using the nuts bolts and washers supplied as indicated in Fig.5.
Now tighten all nuts and bolts previously left finger tight.
Fig.3
4.6
At least two people are required to turn the assembled
workbench upright and into position for use.
Fig.4
Fig.5
AP0615, AP0620 - 1 - 230207
Advertisement
