6. Gently remove the window from the window frame on
the hinge side. Set window aside for later use.
7. Position the window frame over the area cut into the con-
trol box door in Step 3. Be sure the hinge side of the ac-
cessory unit control display access door is installed to-
ward the top of the unit to prevent water damage to the
unit and controls.
8. With the window frame in position, pass the 4 mounting
screws through the factory-drilled holes in the accessory
and the field-drilled holes in the unit as shown in Fig. 2.
Use screws with correct length for installation. Discard
other screws.
9. Place an O-ring, two washers (if necessary), and a cap nut
over the end of each screw as shown in Fig. 2.
10. After all screws, O-rings, washers (if used), and cap nuts
are installed, tighten the mounting screws to 10 in.-lb. of
torque. At this point, check to be sure that mounting sur-
face gasket is compressed to half its original size.
11. Reinstall window onto window frame, and secure win-
dow using two factory-installed screws in the lower cor-
ners of window.
12. Reinstall, close, and secure the control box door, and re-
store power to the unit.
*And associated modular units (sizes 230-420).
NOTE: Dimensions are in inches, and dimensions in [ ] are in mm.
Fig. 3 — Door Template Locations,
30GN040-420
*And associated modular units (sizes 230-420).
NOTE: Dimensions are in inches, and dimensions in [ ] are in mm.
Fig. 4 — Door Template Locations,
30GT,GU040-420
CONTROL
BOX
DOOR
7.65
[194.2]
10.08
[256.2]
30GX080-176
NOTE: Dimensions are in inches, and dimensions in [ ] are in mm.
Fig. 5 — Door Template Locations,
30GX080-350
2
CONTROL
BOX
DOOR
2.67
[67.7]
8.67
[220.1]
30GX205-350
(SIDE BOX)