LG OLED88Z9PTA Service Manual page 24

(5-1) Insert the Head into the Stand.
* Be careful not to fit the DC Cable between the Head and the Stand.(If necessary, fix the DC Cable with tape before inserting
the Head.)
(5-2) Screw the Shaft(C) 4 EA.
* If the head of the shaft does not protrude from the stand surface, it is normally fastened.
5-1
5-2
C
C
C
(6-1) Tighten the Sound Reflector. (Attached with magnet)
* Check the DC Cable clearance before the Sound Reflector tightening. The Sound Reflector does not tighten properly if the
DC Cable is protruding.
(6-2) Screw the Sound Reflector Fixation Screw(B) 2 EA.
* Be careful not to scratch inside the stand when Sound reflector is assembled to Stand.
6-1
Sound Reflector
6-2
Sound Reflector
Caution Cable
C
C
- 24 -
※Check the DC Cable before assemble Reflector to Stand.
Cable protrudes to the outside (NG)
Reflector attached
by magnet.
B
Copyright © LG Electronics Inc. All rights reserved.
Only training and service purposes.
If necessary, fix the DC Cable with tape
before inserting the Head.
※ The head of the shaft does not protrude
from the stand surface.
Cable does not protrude
to the outside (OK)