Oxy Heli Tareq OXY3 Instruction Manual page 28

-
You should now do some initial setup of your FBL unit and servos.
- We recommend you select a new model in your transmitter, and reset your FBL unit and start with a clean setup in it as well.
- After binding your transmitter to the receiver system used with the FBL unit, work your way through the FBL setup instructions to the point
you plug in your servos.
- Now set your collective stick in the middle position, and position the servo arms as close to the correct positions you can on each servo
see the following pages for arm orientations on the various servos.
- Next confirm the servos work in the correct direction, then return the collective stick to the center position.
- Now use your FBL unit to trim the servos so the arms are exactly horizontal (see pictures below).
- This procedure varies between units. Carefully label the position of the servos, then proceed with the installation of the servos as shown.
Linkage Ball Position
After Cut
Front Cylic Servo
OXY0085 -
Servo Arm
OXY0092
Linkage Bal
OXY0108
M2 Hex Nut
page 27
OXY0085 - Servo Arm
( Box1/Bag 19)
7.50
10
OXY0108
M2 Hex Nut
REF 7.30mm
OXY0085 -
Servo Arm
OXY0108
M2 Hex Nut
OXY0092
Linkage Bal
Chapter 12: Servo & Servo Rod Prepareration
It is really important the servo rods screw onto
the linkages the same amount. The Plastic
ball links have a Lynx logo to give you
information about turn adjustment, but have
a symmetrical ball socket shape and can be
installed in either direction to achieve the
best fine tuning.
OXY0085 -
Servo Arm
OXY0108
M2 Hex Nut
OXY0092
Linkage Bal
OXY0085 -
Servo Arm
OXY0092
Linkage Bal