Advertisement
Blower Operation
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn:
turn the Switch off and unplug the power cord from its electrical outlet before removing the power Head.
table B: recOMMenDeD MiniMuM Wire GauGe
FOr eXtenSiOn cOrDS (120 VOLt)
naMepLate
aMpereS
(at full load)
0 – 6
6.1 – 10
10.1 – 12
12.1 – 16
1. USE PROPER EXTENSION CORD.
Make sure your extension cord is in good condition.
When using an extension cord, be sure to
use one heavy enough to carry the current
your product will draw. An undersized cord will
cause a drop in line voltage resulting in loss
of power and overheating. Table B shows
the correct size to use depending on cord
length and nameplate ampere rating.
If in doubt, use the next heavier gauge.
The smaller the gauge number, the heavier the cord.
Item 56579
eXtenSiOn cOrD
LenGtH
25'
50'
100'
150'
18
16
16
14
18
16
14
12
16
16
14
12
14
12
Do not use.
For technical questions, please call 1-888-866-5797.
cautiOn! Wear anSi-approved
safety goggles before use.
2. Remove Power Head and clean out the
Tank before using the appliance as a Blower.
cautiOn! any material left in the tank
may be blown out, causing injury.
3. Replace Power Head with Power Switch
facing forward. Secure with Clips.
4. Remove Hose from Vacuum Port. Push end of
Hose into Blower Port, on back of Power Head,
until clip on Hose clicks into tab on Port.
5. Turn Power Switch OFF.
Plug Power Cord into electrical outlet.
6. Hold the Hose securely. Turn Power Switch ON.
cautiOn! Do not point Hose toward
another person or animal.
7. To prevent accidents, turn off the appliance
and unplug it after use. Clean, then store the
appliance indoors out of children's reach.
Page 7
Advertisement
