Electrolux WKU30SSP User Manual page 65

decrease key until you reach the
desired temperature.
By default, the temperature
digits show the current
temperature. When you tap
once or start selecting a new
setting, the displayed digits
blink. After 3 seconds
without tapping the keys, the
digits stop blinking and the
current temperature is
displayed.
To set the right temperature for each
type of wine, refer to the "Daily use"
chapter.
5.5 Light setup
Tap the Light key once to turn the light
on or off. The default light setting is 1A
for the light behaviour and 9L for the light
brightness.
The light has no negative
effect on the quality of wine.
You may adjust behaviour and
brightness of the light.
To set the light behaviour or brightness:
1. Tap and hold the Light key for 3
seconds to enter the light setting
menu.
2. Light behaviour A appears. Tap the
Light key again to go to the light
brightness L.
3. Tap the temperature regulators
repeatedly to set the desired light
behaviour or brightness.
Light behaviour (A):
• 1A door open - lights on at the highest
dimming level, door closed - lights
turn off,
• 2A door open - lights on at the highest
dimming level, door closed - lights on
at the selected dimming level,
• 3A door open and closed - lights on at
the selected dimming level,
• 4A door open - lights on at the
selected dimming level, door closed -
lights on at the highest dimming level.
Light brightness (L):
• 9L is the brightest setting while 1L is
the dimmest one.
5.6 Cellaring
In this mode, the appliance switches to
the preset default temperature of 12°C.
To activate the Cellaring mode, tap the
Cellar Mode key. CE on the display starts
blinking. Wait 5 seconds. The mode is
active when CE stops blinking and is lit
at half brightness.
To deactivate the Cellaring mode, tap
Cellar Mode once again. When the
Cellaring mode is deactivated, the
temperature returns to its previous
setting.
5.7 Child Lock mode
Activate the Child Lock mode to lock the
keys from an unintentional operation.
To activate the Child Lock, tap and hold
the Cellar Mode key for 3 seconds.
When the mode is on, the display
alternately shows CL and On lit at full
brightness. After 3 seconds the display
shows the current temperature lit at half
brightness.
If you press any key other
than Cellar Mode, the
display behaves as when the
mode is activated.
To deactivate the Child Lock mode, tap
the corresponding key again. When you
deactivate Child Lock, the display
alternately shows CL and Of lit at full
brightness. After 3 seconds the display
shows the current temperature lit at half
brightness.
The Child Lock mode
deactivates after electricity
interruption or unplugging
the appliance.
5.8 Mute or unmute sounds
The sounds are enabled by default.
To mute or unmute the sounds:
ENGLISH 65