Operation - Toto TLE0150 Series Instruction Manual

3. INSTALLATION PROCEDURE
Before Installation
Before installing the product, be sure to thoroughly flush the
1
supply pipes of dirt and debris.
2
Remove the controller cover, connect backup battery to
controller. Product will require 3 min to initialize.
*ECOPOWER type only
Install the Controller
Mount the bracket on the wall.
1
2 Insert the controller part into the fixing plate and tighten the fixing
nut. (Alignment of D-cut part)
Connect the water supply line to the controller inlet.
3
Install the Spout for Deck-Mounted Models
Secure the Spout to the countertop with the included mounting
1
hardware.
2 Cut the spout connecting hose if necessary. Connect the spout
connecting hose to the controller.
Install the Spout for Wall-Mounted Models
1 Draw the center line of the installation position on a rough wall
as shown in the figure below.
Excavate a rough wall according to the size drawn (excavation
2
depth is 80 mm)
3 Place the connected PVC pipe in the center of the groove (fix it
with a wooden block if necessary)
Secure the wall PVC pipe with cement to decorate the wall
4
(tiles, etc.)* PVC pipe is cut to the same height as the wall
(After the cement is completely dry) Center the center of the
5
PVC pipe and hit it against the wall as shown.
4 holes.
(TLE23004*, TLE23005*, TLE24004*, TLE24010*, TLE24005*, TLE25004*, TLE25005*, TLE25010*)
6
Insert the expansion tube and screw in the screw to secure the spout
base. Insert the faucet and tighten the faucet. Bottom fixing screw
(TLE26004*, TLE26005*,TLE26010*)
Push the expansion tube into the hole. Fix the faucet with screws, attach the
flange to the faucet, The wiring for the water hose and photoelectric sensor is
inserted into the PVC pipe of the pre-filled water nozzle. Tighten the flange.
Guide the water inlet hose and photoelectric sensor wiring from
7
the bottom port of the PVC pipe and attach the flange.
Connect the Spout to the Controller
1 Connect the hose. Secure the hose with a clip.
Place the battery in the battery box. Connect the battery box
2
and controller.*DC type only
Insert the sensor connector till it stops with a click.After inserting the
3
connector, insert the sensor cord into the groove of the controller as shown.
4 Attach the controller cover by the screw.
5 Connect Power plug. *AC type only
After supply electricity, sensor will set up automatically (about 20 seconds).

4. OPERATION

1
1. Place the hands close to the spout.
When the sensor detects the hands, water will discharge automatically.
2. Move the hands away.
After moving the hands away for 1-2 seconds, the water will stop.
Water valve will automatically stops discharging water after
continuously discharging for approximately 1 minute.
(If another discharge is wanted, please move the hands away
and allow the detector to re-sense the hands.)
- 7 -
2