Table of Contents
Advertisement
Carry Strap
If you purchase the carry strap accessory for D
the metal end to mount the accessory.
Locking Locator Clip (Fig. 1, 7)
The locking locator clip (I) keeps the saw from sliding left or right during cutting
operations. To move the clip, remove saw/bracket assembly, loosen the screw in the
center of the clip, slide it to the desired position and tighten the screw. You can then
remount the saw/bracket in the new location.
Removing the Saw
Once the miter saw is fastened to the brackets, it can be removed by grasping the
release levers, pulling up slightly to clear the beam and can be set down on the non
marring feet for transportation or cleaning.
Carry Handle (Fig. 10)
A handle has been supplied to transport the miter saw
stand to and from the work site.
WARNING: To reduce the risk of personal injury, DO
NOT attempt to store or carry the stand with the saw
attached. Loss of control may result.
MAINTENANCE
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING: Since accessories, other than those offered by D
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, do not create unstable conditions and use only with
D
WALT miter saw stands.
E
WALT stands, use the square hole in
E
FIG. 10
WALT, have not been
E
5
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory, please
contact Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call
1800 444 224 or (NZ). 0800 339 258.
Advertisement
Table of Contents
