Definitions: Safety Guidelines; Carton Contents; Tools Required; Components (Fig. 1) - DeWalt DWX723-XE Instruction Manual

Definitions: Safety Guidelines

The definitions below describe the level of severity for each signal
word. Please read the manual and pay attention to these symbols.
DANGER: Indicates an imminently hazardous situation which, if
not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
NOTICE: indicates a practice not related to personal injury which, if
not avoided, may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY D
CALL US AT: 1800 444 224 (Aust) or 0800 339 258 (NZ).
Miter Saw Stand with Folding Legs DWX723-XE/DWX724-XE
This stand is designed for use with most miter saws. If you have any problem with
alignment or mounting, call 1800 444 224 (Aust) or 0800 339 258 (NZ).
WARNING: For your own safety, read the miter saw instruction
manual before using any accessory. Failure to heed these
warnings may result in personal injury and serious damage to the
miter saw and the accessory. When servicing this tool, use only
identical replacement parts.

Carton Contents

1 Miter saw stand (DWX723-XE or DWX724-XE)
2 Miter saw mounting brackets (DW7231-XE)
2 Workpiece support and length stops (DW7232-XE)
1 Hardware bag

Tools Required

• Drill with 9.5 mm (3/8") drill bit (Not required for D
• Crosshead #2 screwdriver
• 13 mm (1/2") Wrench

Components (Fig. 1)

WARNING: Never modify the stand or any part of it. Damage or personal injury
could result.
Refer to Figure 1 for Components List.
GENERAL SAFETY INSTRUCTIONS FOR MITER SAW STANDS
WARNING: To reduce the risk of personal injury:
• ALWAYS use eye protection. All users and bystanders must wear eye protection
that conforms to AS/NZS1337.
WALT TOOL,
E
• ALWAYS check the stability of the miter saw stand and the miter saw attached to
it before putting the stand or the saw into use.
• DO NOT mount any power tool other than a miter saw to this stand. Mounting
other power tools to this stand could result in severe personal injury.
• DO NOT exceed the weight this stand can hold. The main center beam of the
miter saw stand is designed to support 227 kg. (500 lbs.) safely in a work
environment. It is unsafe to climb, sit or stand on the stand.
• Follow the mounting instructions carefully. Fasten the miter saw to the saw
mounting brackets securely as instructed.
• DO NOT modify or use stand for operations for which it is unintended.
• DO NOT use the stand on uneven surfaces. The stand is designed to be used on
a flat, stable surface.
• DO NOT use on a slippery surface. The stand load capacity is greatly reduced
when used on slippery surfaces.
SAVE THESE INSTRUCTIONS
1
WALT Miter Saws)
E