Connecting The Universal Clock Inputs To Ground - Mutec iD Operating Manual

\\\\\\\\\\\\
AP P E N D I X
AP P E N D I X
AP P E N D I X
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >

Connecting the universal Clock Inputs to Ground

CAUTION! Disconnect the unit from the mains before opening!
Remount the steel-plate cover thoroughly before you attempt to operate
Ground connectors J 15, J 16
the unit!
When iD is shipped, the BNC-based universal in- Jumper:
puts are isolated to ground to avoid interference
from the connected clock line.
Setting the jumper one pin forward in direction
to the housing's backside will disconnect the ac-
cording BNC input connector from ground. Both
inputs can be set independently.
INPUT 1 INPUT 2
iD rear panel
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >
88
29