Operation - Prokonian SPCT-500-P Instruction Manual

OPERATION

When the unit is connected for the
of the LCD display will turn ON for 3 seconds, as shown in above diagram. After 3
seconds, the thermostat will operate at the preset work mode of 17.5˚C (64˚F)
with the factory preset time and date.
This will happen when the unit is connected for the first time and after the
electricity supply resumes after power failure.
1. Time setting – Press UP and DOWN buttons at the same time.
A. Press the UP or DOWN button to set "HOUR."
B. Press MODE button again and then press the UP or DOWN button to set
"MINUTE."
C. Press MODE button again to set the "DAY" from MONDAY (MO) – TUESDAY (TU)
– WEDNESDAY (WE) – THURSDAY (TH) – FRIDAY (FR) – SATURDAY (SA) –
SUNDAY (SU).
D. Press MODE button again to exit and save the setting.
After exiting the time setting mode, press the UP and DOWN buttons at the same
time to switch between 12 hours and 24 hours time setting.
2. Switching between Celsius (°C) and Fahrenheit (°F) – Press the MODE button and
UP button at the same time to switch the temperature display between Celsius
(°C) and Fahrenheit (°F).
time, all segments (symbols and digits)
3. Activate the back light – Press any button on the control panel to activate the
blue-colour back light. The light will automatically turn off if no button is being
pressed again.
4. Work mode – Under this mode the convector will operate under the pre-set
temperature. Press the MODE button; the convector will now enter HOLD
mode. Then press the UP or DOWN button to adjust the pre-set temperature. The
adjustable range of pre-set temperatures is 5 – 35°C (41 – 95°F).
After 15 seconds, the convector will automatically enter work mode at the
HOLD temperature.
Under this mode, the programming mode will not be activated and the convector
will work under the pre-set temperature continuously.
5. Programming mode – There are 4 programmable settings (P1 to P4). The
convector will work under the preset temperature and time, and will cycle from P1
to P4 every day of the week.
A. Press the MODE button to enter the HOLD mode first.
B. Press the MODE button again to enter the programming mode. The display
will show "P1" flashing.
C. Press the UP or DOWN button to adjust the pre-set temperature.
D. Press the MODE button again to set the "HOUR" by pressing the UP and
DOWN buttons.
E. Press the MODE button again to set the "MINUTE" by pressing the UP and
DOWN buttons. Minutes adjust in 10 minute increments.
F. Press the MODE button again and repeat the steps in (C) to (E) to set the
temperature and time for P2, P3 and P4, Saturday and Sunday.
E.g. P 1 – Temperature 25°C (77°F); time 6:00 AM
P 2 – Temperature 20°C (68°F); time 8:00 AM
P 3 – Temperature 25°C (77°F); time 6:00 PM
P 4 – Temperature 18°C (64°F); time 11:00 PM
The convector will work under the above preset time and temperature from P1 to
P4 every day and the preset program for Saturday and Sunday.
Without pressing any button for 15 seconds, the controls will automatically
save the setting.
3