Installation; Electrical Wiring; Wall Mounting Instructions - Prokonian SPCT-500-P Instruction Manual

INSTALLATION

Tools required:
• Electric drill
• Phillips (cross-head) screwdriver
• Tape measure
Choose a suitable location for mounting the convector. The location shall have
enough space and clearance as illustrated in Fig. 1.
WIDTH OF CONVECTOR
C
15.3 cm
(6 in)
Minimum
clearance to
adjacent
surface
E
Fig. 1
MODEL A B
(cm) (cm)
SPCT-500-P 44.5 34.0
SPCT-1000-P 54.0 33.7
SPCT-1500-P
58.2 33.7
CVP-1500
SPCT-2000-P 72.5 48.0

WALL MOUNTING INSTRUCTIONS

1. Release the mounting bracket by pressing the locking brackets on both sides.
2. Use the mounting bracket as a template by holding it against the wall as
illustrated in Fig. 1.
3. Follow the dimensions specified in Fig. 1 and place mounting bracket in the
desired location.
4. Mark the 4 screw holes. Place mounting bracket on the screw markings and
ensure the mounting bracket is perfectly level.
5. Predrill holes and insert 4 wall anchors. Wall anchors are needed for mounting
on drywall or concrete walls. Ensure you use the proper anchors for your wall
type.
6. Replace the mounting bracket and fasten it with screws (minimum 4 screws).
7. Mount the convector to the mounting bracket and engage the 2 locking brackets
at the top. See Fig. 2.
CAUTION: HIGH TEMPERATURE, RISK OF FIRE. KEEP ELECTRICAL CORDS, DRAPERY,
FURNISHINGS AND OTHER COMBUSTIBLES AT LEAST 90 cm (3 feet) AWAY FROM THE
FRONT OF THE HEATER AND AWAY FROM THE SIDE AND REAR OF HEATER.
WARNING: TO REDUCE RISK OF FIRE, DO NOT STORE OR USE GASOLINE OR OTHER
FLAMMABLE VAPOURS AND LIQUIDS IN THE VICINITY OF THE HEATER.
A
D
B
15.3 cm
(6 in)
Minimum
clearance to
adjacent
surface
E
Minimum
15.3 cm
distance
(6 in)
to ground
C D
(cm) (cm)
4.5 6.5
8.5 12.5
10.3 14.7
11.4 13.8
Wall bracket
Wall
Fig. 2

ELECTRICAL WIRING

WARNING: THIS CONVECTION HEATER IS TO BE USED ON A 240 VAC POWER SUPPLY AND
GROUNDED OUTLETS.
E
(cm)
21.5
24.8
20.8
21.5
CAUTION: TURN OFF MAIN POWER BEFORE BEGINNING INSTALLATION TO AVOID
ELECTRIC SHOCK.
WARNING: THE HEATER MUST BE INSTALLED BY A CERTIFIED
ELECTRICIAN AND IN ACCORDANCE WITH ALL LOCAL AND
NATIONAL ELECTRICAL CODES.
1. Connect white-coloured neutral wire (N).
2. Connect black-coloured live wire (L). .
3. Connect green-coloured ground wire. All connections use twist-on wire
connectors. Put all wires properly into the junction box before replacing
cover with the provided screw.
2
Convector
ALARM LIGHT
THERMAL
MAIN PCB
CUT-OFF
PROTECTION
HEATER
LCD
SENSOR
BLACK (L)
WHITE (N)
GREEN/YELLOW (G)