Changing The Battery; Cleaning; Fault/Remedy - ADE BA 914 Operating Instructions Manual

Changing the battery

Changing the battery
A change of batteries becomes necessary when "Lo" appears on the display, or when
nothing at all is displayed.
When changing the battery, bear the following in mind:
‚ The data that has been ascertained and entered up to that point remains stored
on the scales.
‚ Only use the type of battery that is specified in the "Technical data".
‚ Pay attention to the correct polarity (+/-) when inserting the battery.
The plus pole (+) must point upwards.
‚ Dispose of the old battery in an environmentally responsible way (see "Disposal").

Cleaning

NOTE on material damage
− Do not immerse the scale in water or other liquids.
− Never use harsh, scouring or abrasive cleaning agents or the like to
clean the scale. Otherwise, the surface could be scratched.
1. Wipe the scale as needed with a slightly damp soft cloth.
2. Disinfect the weighing surface and the sensors from time to time using a suitable
disinfecting agent (available at specialist retailers and pharmacies).

Fault/Remedy

Fault
No function
The scale appears to be displaying
wrong weighing results
"Lo" is shown on the display
26
Possible cause
‚ Are the batteries empty or inserted the
wrong way around?
‚ Is the scale located on a firm, even surface?
‚ Is a device that can cause electromagnetic
disturbances located in the vicinity of the
scale?
‚ Remove the batteries from the scale and
wait a moment. Reinsert the batteries. The
data stored until then are retained.
‚ The batteries are empty, see "Changing the
battery".
BA 914 body analysis scale