Bluebell BC368 Operation Manual page 9

BC368D only:
SFP 1 must be fitted with a receiver cartridge and SFP 2 must be fitted with a transmitter
cartridge. The BC368D is configured for two separate, identical signal paths between the two
SFPs; dual channel cartridges will need to be fitted in both carriers to take advantage of this.
However, single channel cartridges may be fitted if only a single signal path is needed. The
signal paths are shown in the diagram below:
The receivers in fibre-optic SFP cartridges are wideband; the BC368D may therefore be used
to retransmit a signal at a different optical wavelength from the one it is received at. This
principle may, of course, be extended to two separate signals by using both signal paths.
If one SFP is fitted with "copper" connectivity (e.g., SDI, HDMI, etc.), optical signals may be
converted to or from electrical format.
TOP
B
SFP 1
A
(dual receiver)
A
SFP 2
B
(dual transmitter)
Rx2
Rx1
Tx1
Tx2
BC368-OperationGuide-v1 9