Table of Contents
Advertisement
ST9655 Family Product Manual, Rev. A
13
2.0 Drive mounting and configuration
2.1 Handling and static-discharge precautions
After unpacking, and prior to installation, the drive may be exposed to
potential handling and ESD hazards. Observe standard static-discharge
precautions. A grounded wrist-strap is preferred.
Handle the drive only by the sides of the head/disc assembly. Avoid
contact with the printed circuit board, all electronic components and the
interface connector. Do not apply pressure to the top cover. Always rest
the drive on a padded antistatic surface until you mount it in the host
system.
2.2 Mounting the ST9655 family drives
You can mount ST9655 family drives in any orientation. Allow a minimum
clearance of 0.030 inches (0.76 mm) around the entire perimeter of the
drive for cooling airflow.
Figure 3 on page 14 provides mounting dimensions for the ST9655 family
drives. These drives conform to the industry-standard MCC direct-
mounting specifications and require MCC-compatible connectors in di-
rect-mounting applications.
Caution. To avoid damaging the drive:
• Use M3X0.5 metric mounting screws only .
• Do not insert mounting screws more than 0.150 inches (3.81 mm) into
the mounting holes.
• Do not overtighten the screws (maximum torque: 3 inch-lb).
Advertisement
Table of Contents
