Table of Contents
Advertisement
All manuals and user guides at all-guides.com
CD Player Operation
"NO DISC" is displayed.
• The disc is inserted upside down.
™ Place disc with printed side up.
• Moisture condensation at the lens.
™ Wait until lens has adjusted to normal
room temperature.
• There is no disc in the CD tray.
™ Insert a disc.
• The disc is dirty, badly scratched or
warped.
™ Clean or replace the disc.
• The disc lens is dirty or dusty.
™ See section under Maintenance (page
40).
"DISC NOT FINALIZED" is
displayed.
• The CD-RW or CD-R disc is not properly
recorded for use with a standard CD
player.
™ Read the instruction booklet of your CD-
Rewritable or CD-Recorder on how to
finalise a recording.
• The CD is badly scratched or dirty.
™ Replace or clean CD.
pg 001-41/D5-D1/21-Eng new
41
• Speakers are not connected or are
Radio Reception
connected wrongly.
Poor radio reception.
™ Check that the speakers are connected
• The signal is too weak.
correctly.
™ Adjust the antenna.
™ Make sure the stripped speaker wire is
™ Connect an external antenna for better
clamped.
reception.
Reversed left and right sound.
• The TV or VCR is too closed to the
• Speakers are connected wrongly.
stereo system.
™ Check the speaker connections and
™ Separate the stereo system from the TV
location.
or VCR.
Lack of bass sound or apparently
Cannot tune to radio station.
imprecise physical location of musical
• Wrong tuning grid.
instruments.
™ Switch to the correct tuning grid.
• Speakers are connected wrongly.
™ Check the speaker connection for
General
proper phasing, coloured/black wires to
coloured/black terminals.
System does not react when any
button is pressed.
Remote control has no effect on the
• Electrostatic discharge.
system.
™ Press STANDBY ON to switch the
• Wrong source is selected.
system off. Remove the AC power plug
™ Select the source (CD, TUNER, etc.)
from the wall outlet, then reconnect the
before pressing the function button
power plug and switch on the system
( É , í , ë , etc.).
again.
• The distance to the system is too large.
No or poor sound.
™ Reduce the distance.
• Batteries are inserted incorrectly.
• Volume is not turned up.
™ Adjust VOLUME.
™ Insert the batteries with their polarities
(+/– signs) as indicated.
• The headphones are connected.
• Batteries are exhausted.
™ Disconnect the headphones.
™ Replace the batteries.
TROUBLESHOOTING
Timer is not working.
• Clock is not set.
™ Set the clock.
• Timer is not switched on.
™ Press TIMER to switch on the timer.
Clock setting is erased.
• There was a power failure.
™ Reset the clock.
System displays features
automatically; buttons flash
continuously.
• Demonstration mode is switched on.
™ Press and hold Ç (on the system) for
five seconds to switch off the
demonstration.
There is a howling sound at the
external source.
• You hear feedback when you are
listening in AUX mode
™ Press AUX to select CDR mode.
All lighted buttons are not lit.
• Display is switched on in DIM 3 mode.
™ Press DIM until DIM OFF display mode
is shown.
6/8/01, 11:33 AM
41
3139 115 20054
Advertisement
Table of Contents
