Solight 1L68 User Manual

EN User manual for Solight 1L68 wireless doorbell
Dear customer, Thank you for purchasing our product. Avoid improper handling of this device and always
follow the principles of using electrical appliances. Designed for home or indoor use. Do not expose the
receiver (bell) to an environment with high humidity (e.g. bathroom), avoid contact with liquids.

Description

The set consists of a button (transmitter) and bells (receivers). Bell no.1 is for permanent connection to the 230 V AC/50 Hz power
mains. Bell no.2 is battery-powered. The signal transmission between the button and the bells takes place using radio waves with a
frequency of 433.92 MHz. The range depends on local conditions and reaches up to 200 m in open space without interference. The
set has a so-called pairing function (Learning code) – the button is able to generate its own pairing code that receives the doorbell
and stores it in its memory. The set can thus be expanded with additional transmitters or receivers. The pairing feature also
prevents the set from affecting neighboring doorbells.

Receivers

Bell no. 1: Plug into a 230 V AC/50 Hz power outlet.
Bell no. 2: Open the battery cover and insert 3x AA alkaline 1.5V batteries. Observe the marked polarity. The receiver can be freely
erected, laid down or hung on the mounting hole. Do not cover the speaker.
For both doorbells, set the melody and volume using the control buttons. The volume level changes from lowest to highest and
back again, with one beep each time.
Transmitter:
Replacing the battery: Push the flathead screwdriver into the joint on the short side and open the back cover. Using your finger or
a flathead screwdriver, release the latch also on the short side and swing the inner cover to the side. Unclip the seal protecting the
battery from moisture ingress. Replace the 3V CR2032 battery, observing the marked polarity. Then close the seal and both covers
carefully.
Installation: The transmitter is waterproof and can be placed outdoors. Prefer a location protected from water and excessive heat.
The transmitter can be mounted on a pad using double-sided self-adhesive pads or screws with dowels, without or with a protective
canopy.
Pairing function "Learning code"
The "Learning code" function allows you to pair several bells or buttons into one group or to restore the connection between them.
This allows several buttons to ring one bell or one button to ring several bells. A maximum of 15 buttons can be paired to one bell.
One button can be paired with up to 8 bells.
Assign a new transmitter to a receiver:
1. Plug the receiver into a power outlet. Press and hold the button to change the melody for 3-4 seconds. The LED will flash
rapidly. Release the volume button and allow the LED to flash.
2. Bring the transmitter close to the receiver and press once. The selected melody will play.
This assigns the transmitter to the receiver. The original transmitter is also assigned. Shown in Fig. 1.
Melody change
button
LED diode
Volume change
Bell no.2
button
Installation hole
Space for
batteries
Bell button
Canopy against rain
Name tag with cover
LED diode