Solight 1L56 Instructions

EN 1L56, 1L56B
Wireless doorbell
Dear customer, thank you for purchasing our product. Please read the following instructions carefully and follow them to serve you safely
and to your full satisfaction. This will prevent misuse or damage. Avoid unprofessional handling of this appliance and always observe the
electrical appliance usage guidelines. Keep the instruction manual carefully. For use in the home or indoors. This product should only be used
by an adult. Never expose to environments with high humidity (e.g. bathroom), avoid contact of the product with liquids.

Description:

LED
Note: The doorbell operates at a frequency of 433MHz. The range is max. 120m in open area.

Inserting batteries into the transmitter

Grasp the nameplate and battery cover with two fingers and pull it open. Insert a 12V/23A alkaline battery.
Observe the marked polarization. Close the cover.

Transmitter and receiver location

Before fixing the transmitter, make sure that the doorbell is working properly by plugging the receiver into the socket (AC 230V) where you
want to use it and then pressing the button on the transmitter where you want to fix it. Choose a position where the transmitter is clearly
visible, i.e. on or near the door frame, about 1.5m above the ground. As the transmitter is waterproof, it can be placed outdoors if necessary.
However, prefer a location that protects the transmitter from water and excessive heat. Mounting on a door frame is easier as the transmitter
can simply be screwed to the wood with the back wall,

Doorbell control

To select the melody, use the button as shown in the picture. Press the button to play and change individual melodies. The selection is
automatically saved when playback is finished.
The volume is controlled by the volume change button as shown. When the button is pressed, the current melody is played at the selected
volume level. You can adjust the volume in three levels.

"Learning code" function

The "Learning code" function allows you to pair several bells and buttons into one group. This allows several buttons to ring
one bell or one button to ring several bells (max. 4).
If you need to assign a new transmitter to a receiver, do the following:
- Press and hold the volume button on the doorbell while pressing and holding the button on the transmitter.
-
When the tune "Dong Dong" sounds, release the button on the bell, and a second later release the button on the transmitter.
This assigns the transmitter to the receiver. The original transmitter is also assigned. Shown in Figure 1. You follow a similar procedure to
assign a new receiver to a transmitter. All previously paired receivers are also assigned to a transmitter. Shown in Fig. 2

Unpairing the button from the receiver

Pairing and volume
button
Button to
change the
melody
Bell button
with LED ring
indicator
Cover for
nameplate
and battery
Rear cover opening
latch for wall
mounting
Mounting
hole
Self-adhesive
pads
Mounting
hole