Solight 1L66 User Manual

EN Solight 1L66 Wireless Doorbell User Manual
Dear Valued Customer, allow us to thank you for purchasing our product. Please read the following instructions
carefully and follow them to ensure that your product serves you safely and to your full satisfaction. Avoid an incompetent manipulation
with the device and always follow general principles of using electric appliances. Make sure to retain the present operating manual.
Intended for household or indoor use. The product should only be used by adult persons. Never expose the receiver to environments
with high humidity (such as bathroom), avoid contact with fluids.
Description
Note: The doorbell operating frequency is 433.92 ±1 MHz. The max. operating range is 150m in open area. The transmitter is
equipped with a device converting mechanical energy into electrical energy. You don't need to insert battery or take any special
care of the transmitter.
Location of the transmitter and receiver
Before fixing the transmitter, make sure that the doorbell works properly by connecting it to a power socket (AC 230V) where you
wish to use it, and then by pressing the transmitter button where you wish to mount it. Select a transmitter position making it visible,
e.g. on the door frame or close to it, around 1,5m above the ground. Since the transmitter is waterproof, it can also be placed
outdoors when needed. However, a place protecting the transmitter from water and excessive heat should be preferred. Fixing to a
pad is with selfadhesive tape.
Doorbell control
Choose the melody using the appropriate button shown on the picture. Push the button to play and change the various melodies
available. Your selection will be saved automatically after finishing the melody playback.
To set the volume, use the volume button shown on the picture. Pushing the button will play the current melody with the selected
volume level. The volume can be adjusted in three levels 25 – 110dB(A).
"Learning Code" pairing function
The "Learning Code" function allows multiple doorbells or buttons to be paired within one group, or restore the connection between
them. It is possible to ring one bell with several buttons or to ring several bells with one button. A maximum of 15 buttons can be
paired with one bell. One button can be paired with up to 8 bells.
Assigning a new transmitter to a receiver:
1. Plug the receiver into a power socket. Press and hold the volume change button for 3-4 seconds. Once the LED starts flashing
quickly, release the button and let the LED flash.
2. Move the transmitter closer to the receiver and press twice. The third press plays the selected melody.
This assigns the transmitter to the receiver. The original transmitter is also assigned. Shown in Fig. 1. You do the same when
assigning a new receiver to one transmitter. All previously paired receivers are also assigned to the transmitter. Shown in Fig. 2.
Unpairing transmitter from the receiver, connection reset
If you have more than one transmitter paired to the receiver, you may need to pair one of the transmitters. It may also be that the
wireless connection has stopped working.
Perform the following steps:
1. Plug the receiver into an electrical outlet. Press and hold the volume change button for 8-10 seconds. The LED starts flashing
first quickly and then slowly. Wait for the flashing slowly. Then release the button. The connection memory is cleared. The
transmitters do not ring.
2. Follow the previous paragraph - Assigning a new transmitter to the receiver. You are reconnected.