EN
1L70, 1L70B
Wireless doorbell
The set consists of a bell button (transmitter) and a bell (receiver). The doorbell is designed for permanent connection to 230 V AC/50 Hz mains. The
transmission between the button and the doorbell is via radio waves with a frequency of 433.92 MHz. The range depends on local conditions and can reach
up to 200 m in open areas without interference. The set has a so-called pairing function (Learning code ) - the button is able to generate its own pairing
code, which is then received by the doorbell and stored in its memory. The set can thus be expanded with additional transmitters or receivers. The pairing
function also prevents the set from affecting neighbouring bells. To use the wireless doorbell correctly, read the instruction manual.
Receiver Description:
Transmitter description
Specifications
Transmission range
Transmission frequency
Ringtone volume
Number of melodies
Receiver power supply
Receiver consumption in idle state
Receiver power supply
Receiver protection class
Ring button lifetime
Receiver's operating temperature
Transmitter's operating temperature
Pairing the button with the bell
1. Plug the doorbell into a 230 V AC/50 Hz socket.
2. Long press the pairing button on the doorbell for approx. 5 seconds.
3. Release the button when the indicator light on the doorbell comes on.
The doorbell switches to the pairing mode, which takes 25 seconds. During this time, press the button on the transmitter. When the
doorbell melody sounds, the button is paired (the pairing mode is turned off).
To pair multiple buttons, repeat steps 1, 2, 3 again for each button. A maximum of 8 transmitters can be paired to one receiver. One
transmitter can be paired with up to 20 receivers.
Button 1
Button 3
The battery-free dynamo transmitter generates an electrical signal for ringing
by converting mechanical energy at the push of a button. No need to worry
about expensive battery replacements, especially in winter. Does not require
special maintenance.
1.
LED indicator
2.
Ring button
3.
Drill holes on the mounting pad
150m in open space
433.92 MHz
4 levels 25 - 100 dB(A)
64
AC 230V/50Hz
<0,4W
battery free
IP56
min. 200 000 presses
-10 °C to +40 °C
-20 °C to +50 °C
Button 2
Bell
Button 4
1.
LED indicator
2.
Speaker
3.
Change volume / Pairing
4.
Changing the ringtone
Bell 1
Bell 2
Button
Bell 3
Bell 4
Need help?
Do you have a question about the 1L70 and is the answer not in the manual?
Questions and answers