Advertisement
TROUBLESHOOTING
PROBLEM
Water is not flowing from
tap
Taps are dripping water
Handle is loose
Flange does not screw
down onto basin surface
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty
Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.
Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including
but not limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download
from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free
from operational defects in workmanship and materials for the warranty period as shown on the schedule in
the manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any
defective products manufactured by Galvin Engineering without charge, so long as the terms of the
Manufacturer's warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy
for breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other
property which is damaged if this product does not work properly, other costs resulting from labour charges,
delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,
chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty
shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or
alteration of the product.
CAUSE
Water supply not on
Aerator or flow regulator is blocked by
debris
Ceramic cartridge is worn or damaged
Tap seat is damaged
Screw has come loose
Tap body are set too far out
Version 2, 6 September 2017, 4 of 4
RECTIFICATION
Turn water on
Remove aerator or flow regulator from
tap and remove debris. Install an inline
strainer to stop further blockages.
Remove and inspect the cartridge,
remove debris and /or replace
cartridge if damaged
Refurbish tap seat usiing a reseating
tool
Tighten handle screw
Re-position tap body and breach piece
Advertisement
