Advertisement
5. Secure basin body assembly
Secure in place with supplied washer and locking
nut.
Ensure that the set is installed with hot and cold
in the correct location.
7. Fit dress flange with anti-rotation pin
If the anti-rotation option is required, fit dress
flanges onto body and mark the basin/sink,
remove the flange and drill 3/16" hole
Replace the flanges and screw in the grub
screw to lock.
9. Assemble handles
Fit handles with tamper proof screws, ensure
the correct water temperature identification
buttons are in the handle
Screws must be tightened before the unit is
tested
Version 2, 6 September 2017, 3 of 4
6. Fit dress flanges
Fit washer onto dress flange and tighten.
8. Fit lock sleeves
Fit lock sleeves and tighten to lock entire
unit in position.
Take care not to over tighten.
10. Testing
Connect water supply to basin body inlet.
Turn the handles and ensure that there is
flow from outlet.
Inspect the tap and check for any leaks.
Advertisement
