Other Alarm Visual And Audible Indicators - Kidde 900-CUAR User Manual

3. Other Alarm Visual And Audible Indicators

Operational Mode
normal (standby)
test (button press when
no alarm condition is
present)
(note: test is very loud,
stand a few feet away.)
Smoke or co Alarm
Memory (unit has
experienced a smoke or
co alarm event, or has
detected 100ppm co or
greater.)
tM
Smoke Alarm Hush
Mode
co Alarm Reset
Initiating Alarm
(multiple alarms in an
interconnected system)
6
Visual Indications
AC power: Green LED on
continuously.
DC power: Green LED blinks
approx every 60 sec.
Red LED blinks in time with
alarm pattern.
Smoke: Red LED blinks
every 15 sec.
CO: 2 red LED blinks
every 15 sec.
Red LED blinks every 2 sec.
None
Red LED blinks in time with
alarm pattern indicating that this
is the unit initiating the alarm
in an interconnected, multiple
alarm, system.
NOTE: It is possible for more than
one unit to detect a hazard and
become an initiating alarm unit
(Red LED blinking).
Audible Indications
• Single beep.
• 3 long beeps, pause, 3 long beeps,
4 quick beeps, pause, 4 quick beeps.
After button push, smoke alarm
pattern stops. (If there is too much
TM
smoke to allow Hush , smoke alarm
pattern continues.)
After button push: CO alarm pattern
stops.
Unit in either Smoke or CO alarm
mode.
Action/Note
Perform button press once a week to
verify proper alarm operation.
NOTE: Alarm memory is only retained
for 24 hrs.
Push button to clear Alarm Memory.
This feature is to be used only when
a known alarm condition, such as
smoke from cooking, activates the
alarm.
Push button during Hush TM to clear
Hush TM and perform a test.
Unit is confirming if CO is present or
if it experienced a nuisance situation.
Re-alarm means danger. Move to fresh
air and call 911.